ICOM ic-2720h ユーザーズマニュアル
The sub band mute function automatically cuts out sub band
audio signals when both main and sub band signals are re-
ceived simultaneously.
audio signals when both main and sub band signals are re-
ceived simultaneously.
While operating on the main band, a beep sounds to inform
you that a signal was received on the sub band.
you that a signal was received on the sub band.
q While pushing [SET•
], push [PWR] for 1 sec. to enter
initial set mode.
w Push [SET•
] or [LOW•PRIO] until “SUb” appears in the
display as shown above.
e Rotate the left band’s [DIAL] to select the condition.
r Push [PWR] momentarily, to exit initial set mode and return
to the previous indications.
While pushing [SET• ]
push [PWR] to enter initial
set mode
push [PWR] to enter initial
set mode
MAIN
T X
M
The display shows that
the sub band mute is
turned ON and sub band
busy beep is turned ON.
the sub band mute is
turned ON and sub band
busy beep is turned ON.
19
3
BASIC OPERATION
New2001
■ Sub band mute/sub band busy beep
USING
INITIAL SET MODE
DISPLAY
SUB BAND MUTE
BUSY BEEP
SUb-OF
OFF
OFF
SUb-OF S
OFF
ON
SUb-On
ON
OFF
SUb-On S
ON
ON
IC-2720H.qxd 02.9.9 8:12 Page 19 (1,1)