ICOM IC-703 ユーザーズマニュアル
62
8
SCAN OPERATION
qSelect VFO mode.
wSelect the desired operating mode.
• The operating mode can also be changed while scan-
ning.
eSet [SQL] open or closed.
• See page a left for squelch condition.
rSelect S2.
• Push [DISPLAY] once or twice to select
S.
• Push [MENU] one or more times to select
S2.
tPush [
(F-1)
SCN] to start the scan.
• Decimal point blinks while scanning.
yWhen the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.
sume setting and the squelch condition.
• During scan [TS] can be used only when resume is ON.
uTo cancel the scan push [
(F-1)
SCN].
NOTE: If the same frequencies are programmed
into the scan edge memory channels 1A and 1B,
programmed scan does not start.
into the scan edge memory channels 1A and 1B,
programmed scan does not start.
CH
VFO A
P
O
S1
5
5
3
7
9
20
40
10
60dB
USB
S2 SCN PRI V/M
Select
VFO mode
VFO mode
F-1
then push [
(F-1)
SCN]
[DISPLAY]
[F-1]
[MANU]
[SQL]
■Programmed scan operation
qSelect memory mode.
wClose the squelch with [SQL].
eSelect S2.
• Push [DISPLAY] once or twice to select
S.
• Push [MENU] one or more times to select
S2.
rPush [
(F-1)
SCN] to start the scan.
• Decimal point blinks while scanning.
tWhen the scan detects a signal, the scan stops or
pauses depending on the resume setting.
yTo cancel the scan push [
(F-1)
SCN].
NOTE: Two or more memory channels must be
programmed for memory scan to start.
programmed for memory scan to start.
S2 SCN SEL V/M
Select
memory mode
memory mode
F-1
then push [
(F-1)
SCN]
CH
MEMO
P
O
S1
5
5
3
7
9
20
40
10
60dB
USB
[DISPLAY]
[F-1]
[MANU]
[SQL]
■Memory scan operation
8