ICOM IC-F620-1 ユーザーズマニュアル
7
2
OPERATION
■Turning power ON
q
Push [POWER] to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an opening
message may appear.
w
If the transceiver is programmed for a start up passcode,
input digit codes as directed by your Dealer.
input digit codes as directed by your Dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
e
When the “PASSWORD” indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
inputting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
■Channel selection
Several types channel selections are available, methods may
differ according to your system set up.
differ according to your system set up.
NON-BANK TYPE:
Push
[CH UP]
/
[CH DN]
to select the desired operating chan-
nel, in sequence; or,
push one of the
push one of the
[
CH 1
]
to
[CH 4]
to select a channel directly.
BANK-TYPE:
Push
[BANK]
to select the desired bank number.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
KEY
[P0]
[P1]
[P2]
[P3]
[P4]
NUMBER
0
1
2
3
4
5
6
7
8
9
IC-F510F520_F610F620- 2.qxd 02.2.4 5:22 PM Page j (1,1)