Vizbee SAS ETH101 ユーザーズマニュアル
RFID Ethernet Gateway (FCC ID: 2AA2YETH101)
Installation and Operation Instructions
1.
General
The RFID gateway is used for locating persons and assets in proximity to the device, that are
equipped with a Fireflies RFID tag and to communicate with other RFID readers, relaying all
communication to an Ethernet network.
equipped with a Fireflies RFID tag and to communicate with other RFID readers, relaying all
communication to an Ethernet network.
2.
Installation Instructions
The device may be mounted on any type of support, but for better operation it is recommended
avoiding mounting the device on a metal support.
The device may be mounted on walls, whether horizontally or vertically.
The device may be mounted from ceiling or above suspended ceiling.
The device may be mounted on the floor or under floating floor.
The device can be mounted either by using a standard glue or by screwing it to the support using
the 2 holes at both ends of the device.
avoiding mounting the device on a metal support.
The device may be mounted on walls, whether horizontally or vertically.
The device may be mounted from ceiling or above suspended ceiling.
The device may be mounted on the floor or under floating floor.
The device can be mounted either by using a standard glue or by screwing it to the support using
the 2 holes at both ends of the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference and
following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
may cause undesired operation.
Use those holes for screwing the device to walls