Medical Intubation Technology Corp. X1000 ユーザーズマニュアル
Setting Up the System
1. Remove the Insert Tube and the system unit from the case.
2. Attach the to the system unit
2. Attach the to the system unit
• Connect the tail cord connector of the Insert Tube to the input
connector of the system unit, screw tight the sealing nut.
3. Power on the system by press and hold the
for 3 seconds.
4. Insert the SD card
• Open the peripheral cover on the side of the system unit and insert the
SD card.
Capturing Images
1. Guide the probe to the inspection area.
2. Aim the camera
2. Aim the camera
• Deflect the probe tip by rotating the control wheel.
3. Capture the image.
• Press
to capture desired image.
• Hold
to keep freezing the frame.
Recording Video
• Press
to start recording video.
• Press
again to stop recording.
Review Images or Videos
• Press
to enter browse mode.
• Press
to start playing recorded video.
Turn Off the System
• Press and hold
for 3 seconds to turn off the system.
About the battery
Frequent operations
The system is powered by a non-interchangeable Li-Polymer battery, which provides
approximately 6 hours capacity while fully charged. It takes about 3 hours for the
battery to be fully charged from empty. The system must be charging at room
temperature for best charging capacity.
approximately 6 hours capacity while fully charged. It takes about 3 hours for the
battery to be fully charged from empty. The system must be charging at room
temperature for best charging capacity.
8