KONX INTERNATION LIMITED KXPH ユーザーズマニュアル
12
D Pair
pair ok before use get the product.
1 Pair outdoor camera with indoor monitor
Note: The system only support 3 models as below. User can’t mix them when
purchase. For one-to-one system, adding more outdoor camera or more
indoor monitor can’t become one-to-multiple system.
(1)
One outdoor camera and one indoor monitor system is 1V1 system
Press ‘pair’ button of outdoor camera, indicating light flash, press
and
button of indoor monitor at the same time, the screen will show “... 1v1 pairing”. If
pairing succeeds, the video from outdoor camera will be shown in the screen of
indoor monitor.
(2)
One outdoor camera and up to 4 indoor monitors system is 1VN system
Firstly, press ‘pair’ button of outdoor camera, indicating light flash, press
and
button of indoor monitor at the same time, the screen will show “... 1v4 pairing”.
If pairing succeeds, the video from outdoor camera will be shown in the screen of
indoor monitor.
Secondly, repeat the above operation for each indoor monitor.
(3)
Up to 4 outdoor cameras and one indoor monitor system is NV1 system
Note: To pair this system is more complex than to do the above two systems.
After turn on outdoor camera and indoor monitor, press button ASAP so not
let any part enter into standby mode.
Firstly, press the ‘pair’ button of outdoor camera, indicating light flash, press
and
button of indoor monitor at the same time, the screen will show “... 4v1
pairing”, if pairing succeeds, the video will be shown in the screen of indoor monitor.
Secondly, repeat the above operation as soon as possible until finish all pairing.
Thirdly, check whether pairing is successful, let system power on again, and then
press ‘monitor’ button continuously to monitor each outdoor camera. If each outdoor
camera works, it means that system pairs successfully. Otherwise repeat the first
step.
2 Pair unlock control with door phone system
Unlock control is connected to 12V power adapter. Outdoor camera uses the
battery, or is connected to the power adapter. Firstly press the pair button of unlock
13
control, the pair light will flash once. Press the
button of the indoor monitor
under talk mode, pair light will continuously flash.
Once again press the pair button of unlock control, pair light stops flashing.
Finally press the
button of the indoor monitor under talk mode, the pair light
will flash 3 seconds, it means that pairing is successful.
9. Working environment
(1) Working temperature: -15℃—+55℃ (2) Working humidity: ≤85%
10. Notices
(1) Please don’t cover anything on the Microphone or speaker when it is in
working mode.
(2) Please always use the specified power adapter, or that with the same
model (same standard voltage and current).
(3) Do not attempt to service this product yourself as opening or removing
covers may expose you to dangerous voltage or other hazards.
11. Specifications
Camera
Indoor monitor
Light
Source
6 LED lights
USB
Power
Input:AC 100-240V
50/60Hz
Output:DC 5V/1A
Camera
CMOS 300K pixels
Screen
3.5”TFT 320×240
7”TFT 800×480
Battery BL-5J
1250mAh(option)
Battery
BL-5J 1250mAh
Power
supply
Solar moudle, battery or
5V 1A power adapter
Power
supply
Battery or 5V 1A power
adapter
Size 126×93×42
mm
Size
3.5” 141×87×20 mm
7” 236×130×18 mm