Inkmachines Sweden AB TPS-500 ユーザーズマニュアル
Service and maintenance
InkMachines
TPS-500
Rev 3.0 / 2018-05-25
28 (27)
Caution! Be careful not to damage the electrical board!
Note! Do not remove the electrical board!
3. The battery(e) is located beneath the electrical board(c). Use a tool to push the battery
from the backside.
4. Attach the new battery.
Note! Make sure the battery is placed with the positive terminal (+)
facing away from the circuit board.
5. Reattach the bottom plate(b) to the spring(d) and upside cover(a) by mounting the unit
upside down.
6. Attach the two screws(f).
7. Test that the foot switch is working. Pairing is not needed after battery change.
Reset Powerpack
If you encounter problems with your Powerpack and you have gone through the Troubleshooting guide, see
page 30, then reset the Powerpack according to the instruction below.
page 30, then reset the Powerpack according to the instruction below.
1. Make a hard reset by short circuiting the battery. Use a metal clip or similar to connect
the middle and the negative connection points on the Powerpack, see figure up of.
Note! Do not get alarmed if there is a spark from the unit.
2. The indication light on the Powerpack will extinguish if lit
3. Put the Powerpack on the charger again and it will be reset and repaired to the Main
unit.
4. After charging connect the Powerpack to the Tattoo machine.
-
+