Dysonics Corporation DYSRM001 ユーザーズマニュアル

LED States

 Off (Disconnected)

LED off

 Advertising/Connecting

Blinking red

 Connected

Slow green blink

 Charging

Solid red

 

(plugged into USB)

 Charged

Solid green

 

(plugged into USB) 

Charging

Use the provided micro-USB cable to charge

RondoMotion. You can plug the USB cable

into any USB port, including wall adapters.

Note: RondoMotion may need charged 

before its first use.

Connecting:

1.  Install RondoPlayer via rondoplayer.com

2.  Attach RondoMotion to your headphones

(see Figure 1)

3.  Press the connect button (the LED will blink

RED to show that it is ready to connect)

4.  In RondoPlayer, go to Motion Sensors and

tap “Scan For Sensors.” The discovered

sensors will appear in the sensor list. Tap a

sensor in the list to connect.

5.  Give your RondoMotion sensor a name.

Connect Button

Micro-USB Charging Port

LED Indicator

Disconnecting:

Once you have connected RondoMotion to

RondoPlayer, you can connect and disconnect simply

by tapping RondoMotion’s connect button.

After disconnecting, RondoMotion will enter a sleep

state until connecting again. RondoMotion can sleep

for over a month without needing to be charged

(depending on its charge level prior to sleeping).

RondoMotion works with Bluetooth Smart Ready devices and requires the RondoPlayer app.

To see if your device is supported, or for additional information or support, visit rondomotion.com.

Figure 1: Attach RondoMotion to your headphones using one of the included bands as shown.