Morse Project Inc. 900-00001 ユーザーズマニュアル
bands 5250-5350 MHz and 5650-5850
MHz and that these radars could cause
interference and/or damage to LE-LAN
devices.
MHz and that these radars could cause
interference and/or damage to LE-LAN
devices.
Avertissement:
Le guide d’utilisation des dispositifs pour
réseaux locaux doit inclure des
instructions précises sur les restrictions
susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la
bande 5 150-5 250 MHz sont réservés
uniquement pour une utilisation à
l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes
canaux;
(ii) le gain maximal d’antenne permis
pour les dispositifs utilisant les bandes 5
250-5 350 MHz et 5 470-5 725 MHz doit
se conformer à la limite de p.i.r.e.;
(iii) le gain maximal d’antenne permis
(pour les dispositifs utilisant la bande 5
Le guide d’utilisation des dispositifs pour
réseaux locaux doit inclure des
instructions précises sur les restrictions
susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la
bande 5 150-5 250 MHz sont réservés
uniquement pour une utilisation à
l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes
canaux;
(ii) le gain maximal d’antenne permis
pour les dispositifs utilisant les bandes 5
250-5 350 MHz et 5 470-5 725 MHz doit
se conformer à la limite de p.i.r.e.;
(iii) le gain maximal d’antenne permis
(pour les dispositifs utilisant la bande 5
This device complies with the R&TTE
Directive (1999/5/EC), the EMC Directive
(2004/108/EC), and the Low Voltage
Directive (2006/95/EC) issued by the
Commission of the European
Community.
Directive (1999/5/EC), the EMC Directive
(2004/108/EC), and the Low Voltage
Directive (2006/95/EC) issued by the
Commission of the European
Community.
A minimum separation distance of 0 cm
must be maintained between the user s
body and the device, including the
antenna during body-worn operation to
comply with the RF exposure
requirements in Europe. This device have
been tested to comply with the Sound
Pressure Level requirement laid down in
the applicable EN 50332-1and/or EN
50332-2 standards. Permanent hearing
loss may occur if earphones or
headphones are used at high volume for
prolonged periods of time.
must be maintained between the user s
body and the device, including the
antenna during body-worn operation to
comply with the RF exposure
requirements in Europe. This device have
been tested to comply with the Sound
Pressure Level requirement laid down in
the applicable EN 50332-1and/or EN
50332-2 standards. Permanent hearing
loss may occur if earphones or
headphones are used at high volume for
prolonged periods of time.
This device complies with Industry
Canada license-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference, including interference that
may cause undesired operation of the
device.
Canada license-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference, including interference that
may cause undesired operation of the
device.
Le présent appareil est conforme aux
CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d'en compromettre le fonctionnement."
CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d'en compromettre le fonctionnement."
For support information, visit
www.aether.com/support
www.aether.com/support
Find out more about our policies at
www.aether.com/legal
www.aether.com/legal
MAC
ADDRESS
:
SERIAL
NUMBER
:
Please retain the leaflet for your reference
CE Warning
Industry Canada Statement
Countries List where the device will be
sold to:
sold to:
Austria
AT
MT
BE
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
NL
PL
PT
SK
SI
ES
SE
GB
IS
LI
NO
CH
BG
RO
TR
Belgium
Cyprus
Czech Republic
Denmark
Estonia
Finland
France
Germany
Greece
Hungary
Ireland
Italy
Latvia
Lithuania
Luxembourg
Malta
Netherlands
Poland
Portugal
Slovakia
Slovenia
Spain
Sweden
United Kingdom
Iceland
Liechtenstein
Norway
Switzerland
Bulgaria
Romania
Turkey
Austria
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one of the following
measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet
on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one of the following
measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet
on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
FCC Caution: Any changes or
modifications not expressly approved by
the party responsible for compliance
could void the user's authority to
operate this equipment.
modifications not expressly approved by
the party responsible for compliance
could void the user's authority to
operate this equipment.
This transmitter must not be co-located
or operating in conjunction with any
other antenna or transmitter.
or operating in conjunction with any
other antenna or transmitter.
Operations in the 5.15-5.25GH band are
restricted to indoor usage only.
restricted to indoor usage only.
Radiation Exposure Statement:
This device meets the government’s
requirements for exposure to radio
waves. This device is designed and
manufactured not to exceed the
emission limits for exposure to radio
frequency (RF) energy set by the
Federal Communications Commission of
the U.S. Government.
This device meets the government’s
requirements for exposure to radio
waves. This device is designed and
manufactured not to exceed the
emission limits for exposure to radio
frequency (RF) energy set by the
Federal Communications Commission of
the U.S. Government.
The exposure standard for wireless
device employs a unit of measurement
known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is
1.6W/kg. *Tests for SAR are conducted
using standard operating positions
device employs a unit of measurement
known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is
1.6W/kg. *Tests for SAR are conducted
using standard operating positions
accepted by the FCC with the device
transmitting at its highest certified power
level in all tested frequency bands.
transmitting at its highest certified power
level in all tested frequency bands.
This Class B digital apparatus complies
with Canadian ICES-003.
Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du
Canada.
with Canadian ICES-003.
Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du
Canada.
This device complies with RSS-310 of
Industry Canada. Operation is subject to
the condition that this device does not
cause harmful interference.
Cet appareil est conforme à la norme
RSS-310 d'Industrie Canada. L'opération
est soumise à la condition que cet
appareil ne provoque aucune
interférence nuisible.
Industry Canada. Operation is subject to
the condition that this device does not
cause harmful interference.
Cet appareil est conforme à la norme
RSS-310 d'Industrie Canada. L'opération
est soumise à la condition que cet
appareil ne provoque aucune
interférence nuisible.
Radiation Exposure Statement:
This equipment complies with IC
radiation exposure limits set forth for an
uncontrolled environment. This
equipment should be installed and
operated with minimum distance 20cm
between the radiator & your body.
This equipment complies with IC
radiation exposure limits set forth for an
uncontrolled environment. This
equipment should be installed and
operated with minimum distance 20cm
between the radiator & your body.
Déclaration d'exposition aux
radiations:
Cet équipement est conforme aux
limites d'exposition aux rayonnements IC
établies pour un environnement non
contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 20
cm de distance entre la source de
rayonnement et votre corps.
radiations:
Cet équipement est conforme aux
limites d'exposition aux rayonnements IC
établies pour un environnement non
contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 20
cm de distance entre la source de
rayonnement et votre corps.
This device and its antenna(s) must not
be co-located or operating in
conjunction with any other antenna or
transmitter, except tested built-in radios.
The County Code Selection feature is
disabled for products marketed in the
US/ Canada.
Cet appareil et son antenne ne doivent
pas être situés ou fonctionner en
conjonction avec une autre antenne ou
un autre émetteur, exception faites des
radios intégrées qui ont été testées. La
fonction de sélection de l'indicatif du
be co-located or operating in
conjunction with any other antenna or
transmitter, except tested built-in radios.
The County Code Selection feature is
disabled for products marketed in the
US/ Canada.
Cet appareil et son antenne ne doivent
pas être situés ou fonctionner en
conjonction avec une autre antenne ou
un autre émetteur, exception faites des
radios intégrées qui ont été testées. La
fonction de sélection de l'indicatif du
pays est désactivée pour les produits
commercialisés aux États-Unis et au
Canada.
Caution:
(i) the device for operation in the band
5150-5250 MHz is only for indoor use to
reduce the potential for harmful
interference to co-channel mobile
satellite systems;
(ii) the maximum antenna gain permitted
for devices in the bands 5250-5350 MHz
and 5470-5725 MHz shall comply with
the e.i.r.p. limit; and
(iii) the maximum antenna gain
permitted for devices in the band
5725-5825 MHz shall comply with the
e.i.r.p. limits specified for point-to-point
and non point-to-point operation as
appropriate.
(iv) Users should also be advised that
high-power radars are allocated as
primary users (i.e. priority users) of the
commercialisés aux États-Unis et au
Canada.
Caution:
(i) the device for operation in the band
5150-5250 MHz is only for indoor use to
reduce the potential for harmful
interference to co-channel mobile
satellite systems;
(ii) the maximum antenna gain permitted
for devices in the bands 5250-5350 MHz
and 5470-5725 MHz shall comply with
the e.i.r.p. limit; and
(iii) the maximum antenna gain
permitted for devices in the band
5725-5825 MHz shall comply with the
e.i.r.p. limits specified for point-to-point
and non point-to-point operation as
appropriate.
(iv) Users should also be advised that
high-power radars are allocated as
primary users (i.e. priority users) of the
725-5 825 MHz) doit se conformer à la
limite de p.i.r.e. spécifiée pour
l’exploitation point à point et non point à
point, selon le cas.
(iv) De plus, les utilisateurs devraient
aussi être avisés que les utilisateurs de
radars de haute puissance sont désignés
utilisateurs principaux (c.-à-d., qu’ils ont
la priorité) pour les bandes 5 250-5 350
MHz et 5 650-5 850 MHz et que ces
radars pourraient causer du brouillage
et/ou des dommages aux dispositifs
LAN-EL.
limite de p.i.r.e. spécifiée pour
l’exploitation point à point et non point à
point, selon le cas.
(iv) De plus, les utilisateurs devraient
aussi être avisés que les utilisateurs de
radars de haute puissance sont désignés
utilisateurs principaux (c.-à-d., qu’ils ont
la priorité) pour les bandes 5 250-5 350
MHz et 5 650-5 850 MHz et que ces
radars pourraient causer du brouillage
et/ou des dommages aux dispositifs
LAN-EL.
IC: 11889A-90000001
CAN ICES-3(B)/ NMB-3(B)
CAN ICES-3(B)/ NMB-3(B)
MODEL NUMBER: CNUS01 , CNUS02