Kontron Europe GmbH CLINIC-BPCB101 ユーザーズマニュアル
Clinic-BPC B-101 - User’s Manual (V1.0)
9
4.4. Installed Singleboard
Your BPC-101 system is equipped with the Singleboard B716.
More information and technical data can be found in the specification of the installed mainboard.
This is available after request.
This is available after request.
www.kontron.com
4.5. Installed AC Power Supply Unit
The BPC-101 system has an integrated AC/DC Power Supply Unit.
The BPC-101 system is designed to be powered from an AC power source via an AC power cable (not included).
❏
Before using your system, you should first become familiar with the system components and check
that everything is connected properly.
❏
It is recommended that the last cable attached to the system should be the power cable!
4.6. Accessing Internal Components
This section contains important information that you must read before accessing the internal components. You must
follow these procedures properly when handling any board components of the system.
follow these procedures properly when handling any board components of the system.
Before removing the cover of the BPC-101 in order to gain access to the internal components, the
system must be powered-down and the power cord has to be disconnected from the power source.
system must be powered-down and the power cord has to be disconnected from the power source.
These procedures have to be carried-out only by qualified specialist personnel.
It is not allowed to operate the system without installed cover.
Please observe the safety instruction for handling assemblies with static sensitive device.
Failure to take heed of this warning instruction can result in damage to the device.
Failure to take heed of this warning instruction can result in damage to the device.
4.7. EMC
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.