Ocedo GmbH URSUS ユーザーズマニュアル

ページ / 3
Professional installation instruction
1. Installation personal 
    This product is designed for specific application and needs to be 
    installed by a qualified personal who has RF and related rule knowledge. 
    The general user shall not attempt to install or change the setting.
2. Installation location 
    The product shall be installed at a location where the radiating antenna 
    can be kept 41cm from nearby person in normal operation condition to 
    meet regulatory RF exposure requirement.
3. External antenna 
    Use only the antennas which have been approved by the applicant. The 
    non-approved antenna(s) may produce unwanted spurious or excessive 
    RF transmitting power which may lead to the violation of FCC limit and is 
    prohibited.
4. Installation procedure 
    Please refer to user’s manual for the detail.
5. Warning 
    Please carefully select the installation position and make sure that the 
    final output power does not exceed the limit set force in relevant rules. 
    The violation of the rule could lead to serious federal penalty.
 
Federal Communication Commission 
Interference Statement
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with the
 instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one of the 
following measures:
 
  -Reorient or relocate the receiving antenna.
  -Increase the separation between the equipment and receiver.
  -Connect the equipment into an outlet on a circuit different from that to which 
    the receiver is connected.
  -Consult the dealer or an experienced radio/TV technician for help.
 
IMPORTANT NOTE
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and operated 
with minimum distance 41cm between the radiator & your body.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this 
equipment.
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: 
(1) This device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation.