Shenzhen Fostar Electronic Co. Ltd FC2501PA ユーザーズマニュアル

45

The LAN IP address will disappear on the window of IP Camera Tool when the camera is configuring a wireless 

connection. Wait about 1 minute, the camera should obtain a wireless connection, and the LAN IP of the 

camera will show again on the window of the IP Camera Tool. The IP address may have changed after the 

camera receives a wireless connection; we recommend setting a static local IP address if this IP address 

changes by right clicking the camera in IP Camera Tools, setting a static IP, and pushing OK (see Figure4.36).   

Congratulations! You have set up the wireless connection of the camera successfully.   

Step 01) Press and hold the WPS button for two seconds.   

Step 02) Press the WPS button on your router within 60 seconds. The WPS button is usually on the back or 

side of your router. On some routers, you may need to log in to the web interface and click on an on-screen 

button to activate the WPS feature. If you are not sure where the WPS buttons is on your router, please refer to 

your router’s User Manual. 

The camera will automatically create a secure wireless connection to your router. If you have plugged in the 

network cable, please plug it out. The IP Camera Tool will search the camera’s LAN IP. Make sure the PC and 

the camera share the same subnet. 

NOTE:
The security mode of router cannot be WEP, or else the WPS settings may be failed.