Shenzhen Fostar Electronic Co. Ltd FC2501PA ユーザーズマニュアル

75

Add: Select one preset points and add it to the selected cruise track. 

Delete: Select one preset points you have added to one cruise track, click delete. 

Move up/ down: Select one cruise track, adjust the order of preset points in one cruise track. 

Attention: Considering the life time and thermal issue of the motor, it’s not recommend to do long-time cruise. 

Here section will allow you to set the stop position after the camera reboots.   

It supports three modes: Disable Start-Up, Go To Home Position and Go To Preset Position. 

Disable Start-Up: When rebooting, the camera will not pan / tilt. 

Go To Home Position: When rebooting, the camera will pa Providing Central Management Software to 

manage or monitor multi-cameras n / tilt and stops at center. 

Go To Preset Position: Select one preset position and save it. When rebooting, the camera will pan/ tilt and 

stops at the preset position you have set. 

Figure 4.68

This section explains how to control the access permission by checking the client PC’s IP addresses. It is 

composed of the following columns: Block access from these IP addresses and Only allow access from 

these IP addresses.