XKGLOW LLC XK-CARBON ユーザーズマニュアル
XK
Carbon
Series
WiFi
Controller
Instructions
1
/
3
Installation Guide
1.
Testing
the
lights
before
installation:
a.
Connect
the
lights
and
control
box
following
the
diagram
below.
b.
Connect
the
red
wire
of
the
switch
wire
to
12V
DC
battery
positive.
Connect
the
black
wire
to
12V
DC
battery
negative.
Push
ON/OFF
switch
until
the
little
blue
led
indicator
in
the
switch
lights
up.
c.
Both
the
signal
LED
on
the
control
box
and
the
connected
light
unit
should
light
up.
This
indicates
the
control
box
and
ON/OFF
switch
wire
are
working
appropriately.
d.
Disconnect
from
the
power
source
and
then
unplug
all
connectors.
2.
Planning
mounting
locations:
Disconnect
the
vehicle’s
battery
and
remove
any
body
work
that
will
have
the
LED
lights
located
behind
them.
Clean
the
mounting
surface
before
attaching
lights.
LOOSELY
mount
the
LED
lights
using double-‐sided tape in the desired locations temporarily with provided extension wires. This controller is
capable of splitting lights into two zones and activating them separately.
using double-‐sided tape in the desired locations temporarily with provided extension wires. This controller is
capable of splitting lights into two zones and activating them separately.
3.
Mounting
the
controller:
Find
a
cool
and
dry
place
to
mount
the
control
unit.
Make
sure
that
the
control
box
is
away
from
any
HOT
parts
of
the
vehicle
like
the
engine
or
exhaust,
and
not
exposed
to
water
or
rain.
4.
Connecting
wires:
As
shown
below,
use
provided
zip
ties
and
wire
clips
to
neatly
mount
and
hide
any
loose
wires.
Make
sure
they
are
not
near
any
hot
parts.
Locate
the
ON/OFF
switch
in
a
dry
and
convenient
location.
Connect
the lights to the output wire from control module.
the lights to the output wire from control module.
5.
Connecting
to
power
source:
Securely
connect
the
input
wire
terminals
to
the
battery
(redà
à
12V
positive.
blackà
à
12V
negative).
Turn
on
the
kit
and
adjust
the
light
for
best
lighting
effect.
Apply
3M
Promoter
on
the
mounting
surface,
and
then
firmly
attach
the
lights
with
3M
double
side
tape.
Use
zip
ties
to
secure
the
strips
if
necessary.
necessary.
6.
Apply
waterproof
tape:
Tightly
wrap
the
connectors
with
provided
elastic
waterproof
tape.
It
is
required
and
the
tape
will
protect
the
connectors
against
long
term
water/moisture
corrosion.