ZOLL Medical I Ltd. UCOR100 ユーザーズマニュアル
User Guide
Kyma µCor
© 2012 Kyma Medical Technologies Ltd. µCor
V.1.0.0
Page 22
7. CLEANING AND MAINTENANCE
7.1. NOTES ON CLEANING AND MAINTENANCE
The µCor System does not require maintenance or cleaning on a routine basis, except as
suggested in this User Guide. Any other service should only be provided by an authorized
Kyma Medical Technologies Ltd. representative. Failure to do so voids the warranty and may
cause user injury.
Please see Appendix B on page 41 for Cartridge battery maintenance and care.
7.2. GENERAL CLEANING PROCEDURES
Note: . The Medical Patch is normally worn by the patient from admission until
discharge. However, see page 17 for conditions that require replacement of the
Medical Patch.
Caution: The Medical Patch is for one-time use on one patient only. A Medical
Patch that has been used once must be discarded. It cannot be reused. Re – using
patches may result in patient cross – contamination and inaccurate measurements
If you replace the Medical Patch on a patient, please be sure to follow the directions on page
17.
Please observe the following cautions when cleaning the Cartridge:
7.2.1. CLEANING THE CARTRIDGE
The plastic and metal outer surface of the Cartridge may be cleaned with a soft, lint-
free cloth dampened in a mild soap and water solution or ethyl alcohol (70-85%).
If disinfecting is required, wipe the surface with isopropyl alcohol (IPA), then wipe
with a water-moistened soft cloth.
Caution: Use cleaning solution sparingly. Excessive solution can cause
damage to internal components.
damage to internal components.
Caution: Contact with solvents can cause severe deterioration of plastic
parts and malfunctioning of the instrument and accessories.
parts and malfunctioning of the instrument and accessories.