RuggON Corporation PM-521 ユーザーズマニュアル
18
Getting Started
Chapter 2. Getting Started
This section provides an outline of the steps necessary to setup a new PM-521. A detailed guide
follows the listed items, see as follows.
follows the listed items, see as follows.
For additional technical assistance, contact your RuggON representative. See “Contacting
RuggON” on page 50.
It is recommended to installing or remove accessories on a clean, well-lit work
surface. To protect yourself and the device from electrostatic discharge, wear anti-
static wrist straps or place the device on an anti-static mat.
surface. To protect yourself and the device from electrostatic discharge, wear anti-
static wrist straps or place the device on an anti-static mat.
First Time Use
1. Open the left I/O compartment cover. See “Opening the I/O Compartment Cover” on page
25.
2. Switch the switch to the ON position.
Figure 8. Switching the Battery Switch
3. Close the left I/O compartment cover. See “Closing the I/O Compartment Cover” on page
26.
Charging the Battery
When you use the AC adapter to connect your PM-521 to a power outlet, the standard and
external (optional) battery will automatically begin to recharge.
external (optional) battery will automatically begin to recharge.
While the battery is charging, the power LED will be active. When the battery is fully charged, the
power LED is lit a solid green.
power LED is lit a solid green.
1. Flip open the DC-IN cover to expose the DC-IN jack.
Figure 9. Opening the DC-IN Cover