BEA 10TD9001HH4 ユーザーズマニュアル
Page 2 of 4
75.5858.02 900 MHZ INDUSTRIAL 20160205
•
The device should not be used for purposes other than its intended use. All other uses cannot be guaranteed by
the manufacturer of this device.
the manufacturer of this device.
•
The installer of the door system is responsible for carrying out a risk assessment and installing this device and the
door system in compliance with applicable national and international regulations and standards on door safety.
door system in compliance with applicable national and international regulations and standards on door safety.
•
The manufacturer of this device cannot be held responsible for incorrect installations or inappropriate adjustments
of this device.
of this device.
PRECAUTIONS
q
Shut off all power going to header before attempting any wiring procedures.
q
Maintain a clean & safe environment when working in public areas.
q
Constantly be aware of pedestrian traffic around the door area.
q
Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions
by the door.
q
ESD (electrostatic discharge): Circuit boards are vulnerable to damage by electrostatic discharge. Before handling
any board ensure you dissipate your body’s ESD charge.
q
Always check placement of all wiring before powering up to ensure that moving door parts will not catch any wires
and cause damage to equipment.
q
Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.
q
DO NOT attempt any internal repair of the components. All repairs and/or component replacements must be
performed by BEA, Inc. Unauthorized disassembly or repair:
performed by BEA, Inc. Unauthorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. May adversely affect the safe and reliable performance of the product resulting in a voided warranty.
Hand Held Configuration
INSTALLATION
Wiring
TERMINAL:
1
2
3
4
5
LABEL:
12-24 V
12-24 V
COM
NO
NC
WIRE COLOR:
red
black
white
green
yellow
SIGNAL:
+ voltage - voltage
common
normally-open
normallyclosed
DESCRIPTION:
power
relay contacts
SETUP
DIP Switches
DIP
STATUS FUNCTION
DESCRIPTION
1
PUL
Pulse Relay
pressing transmitter activates and holds relay according to DIP 2 and 3
TOG
Toggle
Relay
pressing transmitter once activates and holds relay indefinitely
pressing transmitter again deactivates relay immediately (no hold)
2
(PUL only)
0.5s
0.5 second
hold time
relay remains active for 0.5 seconds after transmitter is...
pressed [STD] released [EH]
10s
10 second
hold time
relay remains active for 10 seconds after transmitter is...
pressed [STD] released [EH]
3
STD
standard
hold
relay acts according to DIP 1 and 2
(does not matter if transmitter is pressed/released or pressed/held)
EH
extended
hold
relay remains active as long as transmitter is pressed and held
once released, relay acts according to DIP 1 and 2
1 2 3
ON
1
2
3
Set DIP switches as desired.
Press transmitter twice (blue LED
on receiver will illuminate).
Press and release desired learn button
(red LED on receiver will illuminate)
1
.
NOTES:
1
If Learn w/ Delay button is used, adjust potentiometer (1 s to 30 s).