UCOMTEK CO. LTD SE11D ユーザーズマニュアル
Guide
INSTALLATION
1
2
3
TROUBLESHOOTING:
Plug the Wireless Receiver into your computer’s available USB port.
1.
Your computer’s operating system will automatically detect and
connect the device (this device is plug and play, no driver is
required). Your wireless device is now ready to use.
connect the device (this device is plug and play, no driver is
required). Your wireless device is now ready to use.
2.
2.4GHz Wireless Receiver
Wireless Receiver
USB Port
If you cannot get your wireless device to work after installation try the following:
2. Ensure Power Switch on your wireless device is set to
ON. Then press the
Connect Button to establish wireless connection.
Ensure that the Wireless Receiver is securely plugged into a properly
powered USB port on your computer.
Ensure that the Wireless Receiver is securely plugged into a properly
powered USB port on your computer.
3.
Make sure you are using new batteries and verify they are properly
installed in battery compartment.
installed in battery compartment.
1.
SE11D
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
by the party responsible for compliance could void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.