Mesh Systems LLC DH001 ユーザーズマニュアル
P a g e
| 28
Version 1.0
DOW CONFIDENTIAL - Do not share without permission
Section 4.2: Un-install (Decommission) a Range Extender
Note: A future version of ActiveSense may support synchronous un-installation
.
Step 1: Place the ActiveSense Activator over the Activation Point as indicated for 10 seconds. A
magenta light will illuminate, followed by the Reset Cycle (red, blue, green); a constant red light
indicates the decommission process is complete. While uninstalled, all lights remain off.
magenta light will illuminate, followed by the Reset Cycle (red, blue, green); a constant red light
indicates the decommission process is complete. While uninstalled, all lights remain off.
Figure 26: Range Extender Installation
Step 2: From the Web Portal, navigate to the Site>Range Extenders
Step 3: Select the desired Range Extender and then select Delete this Extender.
Step 3: Select the desired Range Extender and then select Delete this Extender.
This Range Extender is now decommissioned from the previous site. It may now be installed to
another Hub at another ActiveSense site location.
Section 4.3: Un-install (Decommission) a Hub
Note: When moving a Hub to a new site the following decommissioning process must be followed
in order to retain data from the previous site for historical analysis.
Step 1: From the Web Portal, select the Site Information tab then click the Decommission button.
Step 2: Ensure each sensor has been un-installed / decommissioned.
Step 3: Ensure each range extender has been un-installed / decommissioned.
Step 4: Reset the Hub: Resetting the Hub will remove all connected devices from the Hub. To reset
the Hub, press and hold the Set/Reset button on the back of the Hub for approximately 10 seconds. The
Set/Reset button can be released once the Connect indicator begins flashing orange.
Step 2: Ensure each sensor has been un-installed / decommissioned.
Step 3: Ensure each range extender has been un-installed / decommissioned.
Step 4: Reset the Hub: Resetting the Hub will remove all connected devices from the Hub. To reset
the Hub, press and hold the Set/Reset button on the back of the Hub for approximately 10 seconds. The
Set/Reset button can be released once the Connect indicator begins flashing orange.
Note: This step converts the Hub to a ‘like new’ condition, meaning no connectivity with any devices.
This terminates all previously established communication to all devices.
This terminates all previously established communication to all devices.
Step 5: The hub is now available for installation to a new site.
Note: A future version of ActiveSense may support single point un-installation.