LED Roadway Lighting Ltd. 0115 ユーザーズマニュアル
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
fonctionnement.
IMPORTANT: To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is not more than that permitted for successful communication. The antenna used with
this module must be installed to provide a separation distance of at least 20cm from all
persons, and must not transmit simultaneously with any other antenna or transmitter.
Conformément à la réglementation d'Industrie Canada, le présent éemetteur
radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou
inférieur approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut
choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e) ne dépasse pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou
inférieur approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut
choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e) ne dépasse pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
IMPORTANT: The installer of this radio equipment must ensure that the antenna is
located or pointed such that it does not emit RF field in excess of Health Canada limits
for the general population. Consult Safety Code 6, obtainable from Health Canada’s
website www.hc-sc.gc.ca/rpb.
4) United States (FCC)
You must include FCC Regulatory Information on the end product label as well as in the
product manual.
Label Information
This equipment complies with Part 15 of the FCC rules and regulations.
To fulfill FCC Certification requirements, and OEM manufacturer must comply with the
following regulations: (1) The modular transmitter must be labelled with its own FCC ID
number, and, if the FCC ID number is not visible when the module is installed inside
another advice, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module.
This exterior label can use wording such as the following:
product manual.
Label Information
This equipment complies with Part 15 of the FCC rules and regulations.
To fulfill FCC Certification requirements, and OEM manufacturer must comply with the
following regulations: (1) The modular transmitter must be labelled with its own FCC ID
number, and, if the FCC ID number is not visible when the module is installed inside
another advice, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module.
This exterior label can use wording such as the following:
Example of label required for OEM product: “Contains FCC ID:2ACR30115”