3D Systems Corporation MERCURY ユーザーズマニュアル
3D Systems, Inc.
2
p/n 77-D005 Rev_A
Operational Mode Screen
From the Main Control Screen, use the dial to highlight the menu item, Operational
mode and press the dial to select .
mode and press the dial to select .
This menu allows the user to choose the mode of material handling for the ProX MQC
Single Use System .
Single Use System .
•
Full Cycle will allow the ProX MQC Single Use System and printer to
control all material handling in fully-automatic mode.
control all material handling in fully-automatic mode.
•
Local Cycle is the same as Full Cycle, except that all printer powder
requests are ignored by the ProX MQC Single Use System.
requests are ignored by the ProX MQC Single Use System.
•
Choose Stop Cycle to turn material handling off.
Main Control
> Operational mode
+ Load fresh powder
+ Start/stop cool cycle
> Setup/Service/Diag
+ Activate Svc mode
- Deactivate Svc mode
Operational mode
+ Run Full cycle
+ Run Local Cycle
+ Stop Cycle
System Setup/Service Screen
From the Main Control Screen, use the dial to highlight the menu item Setup/service, and
press the dial to select . The Service option is for Certified Personnel only and not available to
press the dial to select . The Service option is for Certified Personnel only and not available to
the user .
System setup/service
From this screen, you can:
> Diagnostics
> Setup
•
Navigate to the Diagnostics screen.
> Service
•
Navigate to the Setup screen .
+ Version info
•
Navigate to the Service screen. This is available to certified personnel only.
•
View the Version information for the software installed on the ProX MQC Single Use System .
Power
Switch
Control
Knob