3D Systems Corporation PJ2500 ユーザーズマニュアル

3

• 

Disposal of fully cured parts are not subject to regulations of any known agency 
worldwide . VisiJet® support material cartridges may be disposed of in ordinary 

office trash.

• 

Uncured part material is classified as regulated, and in some areas hazardous; 
requiring special packaging, transportation, and disposal . The disposal of partially 
cured or uncured part material must comply with all local, state, and federal envi-
ronmental safety regulations . Applicable part “waste” includes cartridges (empty or 
full) and waste pans . Any materials used to clean up uncured part material should 
be disposed of in the same manner as uncured part material . 

• 

To find out facility disposal requirements, contact a local waste disposal provider. 

(Local environmental regulatory agency should have a list of qualified providers.) 

• 

You will need to give disposal service provider a copy of the part material GHS/SDS, and possibly other forms included in the 

Appendix of your VisiJet® Material Handling Guide, such as Waste Profile Worksheet and SNUR (Significant New Use Regulation 
- U .S . only) . A report will be provided, indicating disposal requirements, as well as a quotation for regularly scheduled pickups . If 
assistance is needed locating a waste disposal provider, or completing a waste disposal form, contact your local 3D Systems 

certified reseller or 3D Systems Technical Support.

• 

3D Systems assumes no liability or responsibility for proper disposal of uncured part material . Proper disposal of uncured part 
material is the sole responsibility of the user .

• 

Any chemical may exert harmful effects if it contacts or enters the body . Uncured material is a sensitizer, and can cause allergic 
reactions if it comes in contact with skin . Always wear nitrile gloves when handling material . Refer to personal protection equipment 

for more information. To avoid sensitization, do not allow uncured material to contact skin. Consult the GHS/SDS for specific 
information about the sensitization potential .

• 

If skin comes in contact with uncured material immediately wash with cold water and soap .

• 

Under normal operation, inhalation is not an expected route of entry . 

• 

Ingestion  - Uncured part material is toxic if ingested .  

• 

Because uncured material is toxic if ingested, it must not be present where food and drink are stored, prepared, or consumed . After 
handling materials, wash hands with soap and cold water before consuming or preparing food . 

• 

Finished (cured) parts can be handled or disposed of the same as standard household plastic products . VisiJet® parts are not 
recyclable . VisiJet® materials are not intended for and cannot be used for medical implant, food or drink handling applications . 

• 

Exposure control - The 3D printer system has a variety of built-in engineering controls which are designed to prevent operator 
exposure . Do not try to change or disable these controls .

• 

Appropriate hygienic practices should be followed, including washing with soap 
and water before meals, breaks, smoking, applying cosmetics, using toilet facilities, 
and after work .

• 

Employees should be alerted of the need to clean and rinse off any contacted 
surface promptly in order to prevent further contamination . Ensure a convenient 
washroom location is provided with access to soap, water, and disposable paper 
towels .