Ulterius Technologies LLC FDN40 ユーザーズマニュアル
CHAPTER 15: OSPF
`FDN40ConfigUM/20160505
288
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
vlan11 is line protocol is up
Internet Address 10.4.0.1, Mask 255.255.0.0, Area 0.0.0.0
AS 1, Router ID 10.10.2.1, Network Type BROADCAST, Cost 20
Transmit Delay is 1 sec, State 4, Priority 1
Designated RouterId 10.10.2.1, Interface address 10.4.0.1
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 120, Wait 120, Retransmit 5
Hello due in 4 sec
Neighbor Count is 0, Adjacent neighbor count is 0
15.5.10.2 WEB Configuration
OSPF Interface Cost can be configured through WEB interface using the
OSPF Interface screen. For screenshot, refer section 4.5.3.2.
OSPF Interface screen. For screenshot, refer section 4.5.3.2.
Restore the default value for interface cost by executing the following
command. UltOs(config-if)# no ip ospf cost
15.5.11 Configuring OSPF Authentication
The authentication type for OSPF can be configured as “Simple Password
Authentication”, “Message-Digest Authentication” or “Null Authentication”.
The following sections describe the configuration of OSPF Authentication.
Authentication”, “Message-Digest Authentication” or “Null Authentication”.
The following sections describe the configuration of OSPF Authentication.
Authentication related configuration are done in the Interface Configuration
mode.
Execute the following commands prior to the configuration of OSPF
Authentication.
1. Enter the Global Configuration mode in FDN40-1.
UltOs# configure terminal
2. Enable OSPF globally in the switch FDN40-1.
UltOs(config)# router ospf
3. Configure the OSPF router-id.
UltOs(config-router)# router-id 10.10.2.1
4. Enable OSPF over the VLAN interface (VLAN Interfaces vlan11 and
vlan10 already created as part of prerequisite configuration) and
associate the interface with an OSPF area.
associate the interface with an OSPF area.
UltOs(config-router)# network 10.4.0.1 area 0.0.0.0
UltOs(config-router)# network 10.10.2.1 area 0.0.0.6
UltOs(config-router)# exit
5. Enter the Interface Configuration mode.
UltOs(config)# interface vlan 11