Ulterius Technologies LLC FDN40 ユーザーズマニュアル
CHAPTER 3: DHCP SERVER
Configuration User Manual
63
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
3.5.3.2
Configuring End IP for the Pool
Refer Figure 3-1 for Topology Setup. End IP is used to specify the upper limit
for IP addresses in an address pool.
1. Execute the following command in FDN40-1.
for IP addresses in an address pool.
1. Execute the following command in FDN40-1.
Enter the Global Configuration mode.
UltOs# configure terminal
Create pool 1 and enter into DHCP Pool configuration mode.
UltOs(config)# ip dhcp pool 1
Configure the network as 12.0.0.0, mask 255.0.0.0 and end IP
12.0.0.100.
12.0.0.100.
UltOs(dhcp-config)# network 12.0.0.0 255.0.0.0 12.0.0.100
Exit from the DHCP Pool configuration mode.
UltOs(dhcp-config)# end
2. View the end IP for the pools using the following command.
UltOs# show ip dhcp server pools
The output in FDN40-1 is
Pool Id : 1
-------------------------------------
Subnet : 12.0.0.0
Subnet Mask : 255.0.0.0
Lease time : 3600 secs
Utilization threshold : 75%
Start Ip : 12.0.0.1
End Ip : 12.0.0.100
3.5.3.3
Configuring Lease Time
Refer Figure 3-1 for Topology Setup. Lease time specifies the amount of time
that the client can use the IP address assigned by the server. This parameter
is specific to each IP address pool. Hence, every IP address allocated from a
pool will be returned to the pool, if the client does not renew it.
1. Execute the following commands in FDN40-1.
that the client can use the IP address assigned by the server. This parameter
is specific to each IP address pool. Hence, every IP address allocated from a
pool will be returned to the pool, if the client does not renew it.
1. Execute the following commands in FDN40-1.
Enter the Global Configuration mode.
UltOs# configure terminal
Create pool 1 and enter into DHCP Pool configuration mode.
UltOs(config)# ip dhcp pool 1
Configure the lease time as 1 day 2 hours and 30 minutes.
UltOs(dhcp-config)# lease 1 2 30
Exit from the DHCP Pool configuration mode.
UltOs(dhcp-config)# end
2. View the lease time of pools using the following command.