Zeeva International Limited HP-0288 ユーザーズマニュアル

                                                             

user's Guide

 

 
The main function 
1, a single English tips 
2, voice reporting 
3, automatic reconnect, re-enter pairing mode shape from Rom 
4, low power tips 
5, the end of the number redial 
6, volume synchronization, the default is the maximum volume 
7, power synchronization 
 
Key Description 
Turned off:: Play / Pause long press the power back even unsuccessful automatically enters 
pairing state 
Boot state: long press 3 seconds off 
Connected state: Double-end number redial 
Short press the play / pause music 
When there is an incoming call, press to answer a call, press to reject a call 
During a call, short press to hang up the current call, 
Volume increase: Long press the volume up plus, short press play the next song 
Volume down: Press down volume down, play on a short press 
LED lights: 
Even back state, blue lights flash 
The connection is successful, long bright blue light 
Play sound state, blue light flashes one second slower 
 
Voice prompts: on, off, pairing, connect, disconnect, low battery, ringtones and message number, 
the maximum volume / minimum volume alarm 
Low voltage of 3.2V, the shutdown voltage is 3V, low battery alarm is from 3.2V to 3V every 30 
seconds 

 
This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired operation.     

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications. However, there is 
no guarantee that interference will not occur in a particular installation. If this equipment does