Zeeva International Limited SP-0432 ユーザーズマニュアル

1. Use the Micro USB cable provided with this wireless speaker. 
2. Connect the Micro USB plug to Micro USB charging port on the speaker, then 
    connect the USB plug to a USB port on a computer or wall adapter to begin charging.
3. The light will turn red while charging and will turn off once fully charged.

Slide the ON/OFF Switch to the right.

Slide the ON/OFF Switch to the left.

 

 4. You will hear a beep sound when pairing is successful. 

When powered on, the wireless speaker will automatically connect with the last 

successfully paired device.

2. Power on the wireless speaker.
3. Activate the Bluetooth function on your phone within range and select 

    “LIGHTUP LEDSPKR” from the list shown.

• You must select a qualified charger from a regular manufacturer. 

• You must charge the wireless speaker if it has been not used for more than 12 months.

Translucent Light Up Wireless Speaker x 1pc
Micro USB Charging Cable x 1pc
User Manual x 1

Ensure that your speaker is in pairing mode or reconnection mode.

Ensure that Bluetooth search function of your mobile device is activated.

1. Keep the distance between your wireless speaker and mobile phone 

    (or other devices) within 32.8 Feet.

Driver Diameter: ----------------------------------------------------------- 40mm
Impedance: ----------------------------------------------------------------- 4 Ohms
Frequency Response: --------------------------------------------------- 20Hz - 20KHz
Battery Capacity: ---------------------------------------------------------- 300 mAh
Battery Type: --------------------------------------------------------------- Li-ion Battery 3.7V
Playing time: ---------------------------------------------------------------- 1-2 hours 
Bluetooth Range: ---------------------------------------------------------- 32.8 Feet
Bluetooth Version: --------------------------------------------------------- 4.1

If you use a power outlet, ensure that the power supply is connected securely 

and the outlet works. If you use a computer, ensure that it is connected and the 

USB port is powered.

FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that 
may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the 
   receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

FCC ID:  2ADM5-SP-0432  

RF Warning Statement:

The device has been evaluated to meet general RF exposure

requirement. The device can be used in portable exposure

condition without restriction.

On/Off

Switch

Micro USB 

Charging Port

OFF/ON

DC5V

LED Light

Indicator