AirLink ASW308 ユーザーズマニュアル

 
 
 
 

 
 

 Operating Environment 

 
This switch must be installed and operated within the limits of specified 
operating temperature (32~131

0

F) and humidity (10~90% 

Non-condensing). Do not place objects on top of the unit. Do not obstruct 
any vents at the sides of the unit. Do not position the unit near any 
heating source such as heater, radiator, or direct exposure to sun. 
Prevent entering of water and moisture into the unit. If necessary, use 
dehumidifier to reduce humidity. 

 Connecting to network devices 

 
The RJ-45 ports on the switch support Auto-MDI/MDI-X function which 
allows using straight-through or cross-over type cables to connect this 
switch to workstation or hub. 
 
Connect one end of the network cable to the RJ-45 port on the rear panel, 
and connect the other end of the network cable to the RJ-45 port on the 
network device. Follow the same procedure to connect all the RJ-45 ports 
of the switch. The UTP network cables must be two pairs Category 5 for 
100Mbps data transmission; two pairs Category 3, 4 or 5 standards for 
10Mbps data transmission. Maximum length, using UTP cable, between 
the switch and connected device is 100 meters (300ft).   
 

 Connecting the power 

 
Connect the output end of the power adapter to the power connector on 
the right panel of the switch. Connect the power adapter to the power 
outlet. The green Power LED on the front panel should be lit. Once the 
network cable is connected to both ends in Step 1 and the attached 
network device is powered on, the green LNK/ACT LED should be lit.