B & M Merchandise LLC HDR ユーザーズマニュアル
The antenna cable:
After fixing the antenna, pull the cable through to the driver’s cab. It is recommended that you
add it to the existing cabling and attach by fastening straps. The length of the cable from the
antenna to the coupling connector is 1.7 meters. The length of the second part of the cable is 2.5
meters. Antenna connector is waterproof and allows easy connection and disconnection when
changing the point of antenna mounting or replacing the antenna.
add it to the existing cabling and attach by fastening straps. The length of the cable from the
antenna to the coupling connector is 1.7 meters. The length of the second part of the cable is 2.5
meters. Antenna connector is waterproof and allows easy connection and disconnection when
changing the point of antenna mounting or replacing the antenna.
When pulling the cable through, keep in mind that the cable must not touch any hot parts of the
car or be installed in places with higher temperature, and must not be attached to any moving
parts of the car!
car or be installed in places with higher temperature, and must not be attached to any moving
parts of the car!
To pull the cable through to the driver’s cab, use the hole with diameter of about 8 mm. If there is
no free hole available, drill a hole in a suitable place. The drilled hole should be adjusted so that
the cable is protected against accidental abrasion, for example by using a rubber grommet. When
drilling the hole, keep the utmost care not to damage surrounding cabling.
no free hole available, drill a hole in a suitable place. The drilled hole should be adjusted so that
the cable is protected against accidental abrasion, for example by using a rubber grommet. When
drilling the hole, keep the utmost care not to damage surrounding cabling.
12V power supply:
After the mechanical installation of the radar antenna and cabling, connect the cabling to power.
Connect the black wire to -12V, and the red wire with a fuse to +12V.
Connect the black wire to -12V, and the red wire with a fuse to +12V.
Before connecting the +12V power supply, remove the fuse from the case because of the
possibility of a short circuit during installation
possibility of a short circuit during installation
It is recommended to connect cables to a switched power source (No. 15). When connecting
cables to a constant power supply (No. 30), it is recommended to use a delayer so that the
antenna is not powered continuously; this avoids discharging of the vehicle battery.
cables to a constant power supply (No. 30), it is recommended to use a delayer so that the
antenna is not powered continuously; this avoids discharging of the vehicle battery.