Zhuhai Pantum Electronics Co. Ltd 5103MFP ユーザーズマニュアル

ページ / 103
2. Make sure the printer is in ready state.
Note
• If the printer is in sleep mode, it can be woken up by pressing any key on the control panel of printer.
3. Press the “Wi-Fi key” on the control panel of printer for more than 2s until the blue Wi-Fi indicator of printer blinks, and then release pressing.
4. Press the WPS key on access point (wireless router) within 2min and then release it.
5. When the access point (wireless router) and printer start to connect, the blue Wi-Fi indicator of printer starts to blink. The blue Wi-Fi indicator of printer will be normally on after
successful connection
.
If the connection is not established after more than 2min, the printer will return to its ready state, the Wi-Fi indicator will be off 
and Wi-Fi Protected Setup (WPS) connection will
fail. If it is needed to connect again, please repeat steps 3-4 above.
Note
• Please refer to 
Chapter 1.5
 for how to cancel and disconnect Wi-Fi connection.
• After successful Wi-Fi Protected Setup (WPS) connection, please install a driver if you want to print via wireless network. Please select “Wireless network
connection (W)” as installation method (please refer to 
Chapter 3.1.3
 for Windows system and 
Chapter 3.3.3
 for Mac system).
5.1.3.How to disable the Wi-Fi network connected
IPlease complete the wireless network connection in infrastructure mode according to above steps. If connected, the Wi-Fi indicator on the status control panel will be always on
; now if you want to disconnect it, please press and hold this key for more than 2 seconds (the Wi-Fi indicator will be off
).
5.2.Wi-Fi Direct mode
You can connect wireless client (including the computer and mobile device with wireless network feature) to wireless network printer without using the access point (wireless router).
5.2.1.Preliminary preparations
1. Printer with the Wi-Fi Direct feature.
2.Wireless client (including computer and mobile device with wireless network feature).
5.2.2.Wi-Fi Direct connection
The Wi-Fi Direct connection feature of printer must be on if it is needed. The method to turn it on is: pressing the “Menu key” – “Menu Setting” – “Network Set” – “Wi-Fi dir.” – “Manual”
(or “Auto”) of the control panel of printer, or logging in the embedded Wed server to turn it on, please refer to 
Chapter 6.2.2.4
.
5.2.2.1.Connection method of wireless client that supports Wi-Fi Direct feature (direct invitation to connect)
You must use mobile devices that support Wi-Fi Direct function for Wi-Fi Direct connection. The operating steps may differ because of the mobile device you are using.
1. Turn on printer power.
2. Turn on the mobile device and select setup to enter Wi-Fi connection interface.
3. Select “Advanced” and then select “Wi-Fi Direct” in advanced WLAN interface.