FENIX TRADING COMPANY S.A. FENIXPLUS ユーザーズマニュアル

User    Manual 

38 

Changes or modifications not expressly approved by the party responsible for compliance could void the user's 

authority to operate the equipment.   

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules.    These limits are designed to provide reasonable protection against harmful interference in 

a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures: 

-- Reorient or relocate the receiving antenna.   

-- Increase the separation between the equipment and receiver.   

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.   

-- Consult the dealer or an experienced radio/TV technician for help 

 

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this 

device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation

 

FCC Radiation Exposure Statement 

This equipment complies with FCC RF radiation exposure limits set forth an uncontrolled environment. This 

transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

The device was tested and complies to measurement standards and procedures specified in FCC OET Bulletin 

65, Supplement C 

This device meets the government’s requirements for exposure to radio waves. 

This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) 

energy set by the Federal Communications Commission of the U.S. Government. 

The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR 

limit set by the FCC is 1.6W/kg. Tests for SAR are conducted using standard operating positions accepted by the 

FCC with the EUT transmitting at the specified power level in different channels. The highest SAR value for the 

device as reported to the FCC is 1.521W/kg when placed next to the body.