Anfair Electronics Plastic Factory MBTK35 ユーザーズマニュアル

• Bluetooth receiver
•  3.5 mm audio cable (3 ft.)
•  3.5 mm male-to-male adapter
•  3.5 mm to RCA adapter
•  Velcro mounting pads
•  Micros USB charging cable
• Carrying pouch
•  Quick Setup Guide

 

 

Before using your new product, please read these instructions to prevent any damage.

 

  Reverse/Volume down 

  Multi-function button (MFB): Power on/off,        

pairing, play, pause, call

  Skip/Volume up 

  LED indicator

  Micro USB charging port 

  Audio jack

  Microphone

Fully charge the Bluetooth receiver before you use it for the first 
time. When the red LED starts to blink during use, it indicates the 
battery is low and requires charging.
1  Plug the micro USB plug of the USB cable into the micro USB port 

on your Bluetooth receiver.

2  Plug the USB end of the cable into an active USB port, or any USB 

charger. A steady red LED indicates it is charging.

3  Disconnect the receiver from the USB cable when the red LED 

indicator turns off. It may take up to three hours to fully charge.

To get started, you need to pair the Bluetooth receiver with 
your phone or device.

With the receiver turned off, press and hold the MFB       for 
seven seconds. The LED flashes and the receiver enters 
pairing mode.

Activate the phone’s Bluetooth function and search for 
your receiver. Click on the product name “NS-MBTK35” to 

connect. See the instructions that came with your 
Bluetooth device for information about pairing.

If you are asked for a password, enter “0000”. When pairing 
is complete, the LED lights solid blue and a tone sounds.

1  Every time the receiver is turned on, it will connect to the 

last connected device automatically. If you want to pair 
with another device, turn off the Bluetooth function of the 
connected device, and repeat the pairing procedure above 
for the new device.

2  If a device does not automatically reconnect, you may 

need to reselect NS-MBTK35 on your Bluetooth device.

3  If the receiver is not paired to a Bluetooth device for three 

minutes, it will turn off automatically. 

1  Press and hold the MFB        for two seconds to turn on your 

receiver. The LED lights solid blue when it is connected to 
your Bluetooth device.

2  When the receiver is turned on, press and hold the MFB 
     for two seconds to turn off the receiver

1  To play/pause audio, press the MFB        once.
2  To increase the volume, press      once.
3  To reduce the volume, press      once.
4  To skip to next track, press and hold      .
5  To skip to previous track, press and hold       .

1  To make a call, use your phone’s controls, then select the 

receiver as the audio source.

2  To answer an incoming call, press the MFB        .
3  To reject an incoming call, press and hold the MFB       . 
4  To end a call, press the MFB        once.

Right

Left

Bottom  

Front

Portable Bluetooth

®

 

Audio Receiver

NS-MBTK35_16-0391_QSG_V1_ENG_FINAL.ai   1   7/14/2016   9:49:17 PM

NS-MBTK35_16-0391_QSG_V1_ENG_FINAL.ai   1   7/14/2016   9:49:17 PM