Tele Supply AS JTM-30C ユーザーズマニュアル
Rev Date
Rev.
Document ID
May 12
th
2016
PN1
5. OPERATOR MANUAL JTM-30
5. JTM-30C NDB Operation User Manual
Copyright 2014 - TELE SUPPLY AS
Page 9(14)
5.4.3 AUTO LEVEL
When activating “AUTO LEVEL” you switch ON the Transmitter and start an internal test
and adjustment. When activating you will see that the window “Pwr correction” first turns
YELLOW and becomes GRAY after finishing adjustment of the RF Power Output.
This is an operation which only may be needed when changing the frequency considerably
and/or if replacing the RF Amplifier. Typical value in the “Pwr correction” window is 35
to 40.
and adjustment. When activating you will see that the window “Pwr correction” first turns
YELLOW and becomes GRAY after finishing adjustment of the RF Power Output.
This is an operation which only may be needed when changing the frequency considerably
and/or if replacing the RF Amplifier. Typical value in the “Pwr correction” window is 35
to 40.
With RF Amplifier Type JTM-30HPA or JTM-30HPA2 this function is not needed.
5.4.4 IDLE
When activating “IDLE” you switch ON the Transmitter, but without generating RF
input/output from the RF Amplifier. This knob is only to check that the Idle current setting
of the RF Power Output Transistors.
Typical reading in the “Current (A)” window is approx. 0,6 to 0.9.
input/output from the RF Amplifier. This knob is only to check that the Idle current setting
of the RF Power Output Transistors.
Typical reading in the “Current (A)” window is approx. 0,6 to 0.9.
5.4.5 STOP
When activating “STOP” you switch OFF the Transmitter.
5.4.6 READ
When activating “READ” you ask the Exciter to send updated information on configured
information to the PC.
information to the PC.
5.4.7 BLOCK A/B
When activating “BLOCK A/B” you stop the operation on Transmitter in operation.
E.g. if Transmitter “A” is in operation and initiation “BLOCK A” you force the transmitter
to switch over to Transmitter “B”.
to switch over to Transmitter “B”.
5.4.8 TRANSMITTER RESET
If the Transmitter in operation (A or B) stops operation and switches over the upper window
of “TRANSMITTER STATUS” turns RED and indicates Alarm.
If you want to reset the Transmitter, or Alarm status, activate “TRANSMITTER RESET”
and the Transmitter will be reset back to normal operation again.
of “TRANSMITTER STATUS” turns RED and indicates Alarm.
If you want to reset the Transmitter, or Alarm status, activate “TRANSMITTER RESET”
and the Transmitter will be reset back to normal operation again.
5.5
Operation from PC locally or via Internet (
Multi Site Mode)
For “Multi Site Mode” operation activate “Multi Site” block located on upper right
PC window
and you will see ”Main Window” to the left and “Multi Site Window” to the right.