Vix Technology Pty Ltd CR6000 ユーザーズマニュアル
VIX Technology
CR6000 user manual
VXP-00404
Revision 1.0
Page 12 of 26
© Vix IP Pty Ltd 2016
Vix IP Pty Ltd Confidential
4
Instructions for users
4.1
Torque settings
The tightening torques of all fasteners must correspond to standards defined by Vix this
being 2.0 Nm for the cradle locking nuts and 0.6 Nm for all fasteners.
4.2
Tools
4.2.1
Standard tools
The following list represents tools and consumables required:
This list is only shown as reference and can be extended depending on the nature of the
task:
This list is only shown as reference and can be extended depending on the nature of the
task:
Air pressure can - oil free.
Plastic cleaning foam.
Screwdriver cross-shaped head screws G n°1, n°2, n°3 Philips.
Screwdriver for 5 and 5.5 hexagonal screws.
Allen screwdriver 5/64.
Set of slotted screwdrivers.
Dry cloth or lint free cloth
4.3
External cleaning of the CR6000 card reader
4.3.1
Required staff and time
1 agent for 2 minutes (once the preliminary instructions are completed).
4.3.2
Preliminary instructions
Switch the card reader off. (Following the version, switch the vehicle off or unplug
the power supply)
the power supply)
4.3.3
Procedure
1. Spray some plastic cleaning foam on the CR6000 card reader.
2. Clean and take out all the residues with a dry cloth or a lint free cloth.
2. Clean and take out all the residues with a dry cloth or a lint free cloth.
Never use alcohol and avoid any abusive water splash.
Excessive use of water or alcoholic cleanser can damage the
CR6000.
Excessive use of water or alcoholic cleanser can damage the
CR6000.