ZONITH A/S BT-ID-BADGE ユーザーズマニュアル
ZONITH Bluetooth ID Badge
User's Guide
6 (6)
It is possible to turn off the LED manually while the badge continues to operate normally.
To turn off the LED press and hold the POWER button for 0.5 seconds. To turn the LED on again
press and hold the POWER button for 0.5 seconds.
press and hold the POWER button for 0.5 seconds.
3.3. Alarm
handling
The ZONITH Bluetooth ID Badge supports two types of alarms from the ALARM button at the back.
There is a short and long button press:
There is a short and long button press:
Name
Press and hold time
Short button press
2 seconds
Long button press
4 seconds
The action that is being done based on the two types of alarms are defined in the ZONITH
Bluetooth Panic Listener.
Bluetooth Panic Listener.
When entering the alarm the LED will change to red constant color.
If the user holding the ZONITH Bluetooth ID Badge does not do anything, then the unit stays in that
alarm situation in 5 minutes. It is possible to leave the alarm state earlier by pressing and holding
the ALARM button for 2 seconds. When the ZONITH Bluetooth ID Badge leaves the alarm
situation the LED will switch back to flashing blue every 4 seconds.
alarm situation in 5 minutes. It is possible to leave the alarm state earlier by pressing and holding
the ALARM button for 2 seconds. When the ZONITH Bluetooth ID Badge leaves the alarm
situation the LED will switch back to flashing blue every 4 seconds.
The ALARM button is located on the back side of the unit and centered. The alarm button is
marked with a 2mm circle around it so that finger can find it without looking at badge itself.
marked with a 2mm circle around it so that finger can find it without looking at badge itself.