ZINUS Co. Ltd ZM1000 ユーザーズマニュアル

 

 

3.  Move the push-button S10 to “B”, then press S3 or S4 to lighten Y section of LED. 

At this moment,Press S2 continuously, the bed BUTT move up, loosen it, the bed 

BUTT stop moving. 

Press S5 continuously，the bed BUTT move down: loosen it, the bed BUTT stop 

moving. 

When in the process of M2, press the safety switch L2, M2 stop falling. loosen the 

safety switch,M2 keep on stopping . 

4.  Move the push-button S10 to “B”, then press S3 or S4 to lighten Z section of LED. 

At this moment,Press S2 continuously, the FEET part move up after flated then 

drive KNEE up in bend state, loosen S2, the bed stop moving. 

Press S5 continuously, the KNEE move down to flat bed, then move down bed FEET. 

loosen S5, bed stop moving. During this course the foreside of bed should keep a 

certain distance with the ground in order to make sure the bed can work safely and 

credibility. 

5.  Move the actuator, when it move to a certain state, press S1,then press S6, the 

position will be memorized. Wherever the motor move, press S6, the motor move 

to the position kept just.    Press S1 and then press S6 when the motor move to 

another place,the position of S6 will be changed.

 

When restart ,memory position is 

the new location. The usage of S7，S8，S9 is same with S6. 

6. Move the key-press S10 to “M”,then press S3 or S4 to lighten X section of LED. 

At this moment,Press S2,the massage motor 1 start vibration,press again, the intensity 

of motor boost up.Press S5 the intensity of motor weaken. The motor have 5 different 

intensity.