Edge-Core EC View Pro NMS 1200 M0YECNMS1T00Z データシート

ECView Pro is Edge-Core’s new generation network management system. It provides a scalable, comprehensive,  
distributed network solution that gives network managers the flexibility to manage mission-critical networks, as well 
as a single point for managers to provision Edge-Core and other vendor’s network devices. ECView Pro discovers 
network devices and generates a TCP/IP topology map showing network inventory, monitors the status of each 
device in the network, correlates and manages simple network management protocol (SNMP) traps or sends emails 
when performance thresholds have been triggered, and generates reports in various formats. ECView Pro can also 
provision through mass deployment, such as scheduled configuration/firmware downloads and updates, monitor 
network health, and gather performance data.

ECView Pro identifies network devices and produces a 
TCP/IP topology map where each device is represented 
by an icon. The IP address discovery function allows 
selection of devices to be discovered and included in the 
topology map. ECview Pro also connects end nodes 
using Edge-Core's proprietary discovery algorithm.

ECView Pro provides an interface for administrators to 
monitor CPU and memory utilization for managed 
devices. RMON is supported to collect statistical data 
from devices, such as bandwidth utilization, errors and 
collisions, packet types, packet groups, and packet 
sizes, which allows administrators to know the network 
performance. Port utilization of  managed devices is also 
monitored. Users can set thresholds, which when 
reached may: send SNMP traps, send emails, block 
ports, play sounds, run custom commands, or invoke 
ECView Pro's system tray and popup window.

ECView Pro supports two levels of configuration 
management; one basic and the other advanced. The 
basic level provides a graphical interface to allow 
administrators to view or configure managed devices. 
The advanced level provides configuration and firmware 
upload and download capabilities, which are useful for 
mass deployment scenarios. Administrators can select 
certain devices from the topology map and perform a 
firmware upgrade or device configuration upload and 
download.

The Event Manager is the center for all events generated 
under ECView Pro including reception of SNMP traps. 
Events can be displayed as on-screen messages or 
saved into a database for later analysis. All event 
messages can also be exported to various file formats.

ECView Pro is an inventory-based system that shows 
the asset information for all devices in the network, 
including WMI devices, such as IP address, MAC 
address, vendor, model, system name, etc. Users can 
query inventory information using different filter types.

Performance thresholds can be set under ECView Pro 
and when reached, causes traps or email messages 
to be sent out to notify the event. ECView Pro has a 
report designer function that can generate new 
reports, or customize existing reports. All data sources 
that are available can be easily integrated into reports.

ECView Pro can support the management of other 
third-party network devices. The following discovery 
protocols are supported: LLDP, CDP (Cisco), FDP 
(Foundry), NDP (Nortel) and EDP (Extreme). Telnet, 
Web, and SNMP management interfaces are available 
for supported network devices.

ECView Pro is able to manage a network device 
through the MIB Browser. A MIB can be compiled and 
stored into a database, which allows users to manage 
the device though the MIB Browser.

ECView Pro is able to indentify key hardware and 
software components on Microsoft network devices 
and monitor the status through WMI. Using ECView 
Pro WMI monitoring, disk utilization, CPU utilization, 
memory utilization, session monitoring and process 
availability checks are simple to perform. 
Administrators can receive notifications of any service 
failure by trap or email message.