Zebra USB2.0 - miniUSB2.0 P1031365-055 ユーザーズマニュアル
製品コード
P1031365-055
16
QLn Series User Guide
Model UCLI72-4 Quad Charger
The UCLI72-4 Quad Charger is designed to charge up to
four QLn battery packs simultaneously. Batteries must be re-
moved from the printer to be charged in the Quad Charger.
moved from the printer to be charged in the Quad Charger.
1. Ensure that the charger has been installed properly per
the Quad Charger instruction manual. Ensure that the
power indicator on the front panel is on.
power indicator on the front panel is on.
2. Remove any protective shrink-wrap and labels from all
battery packs prior to use. Plug a battery pack into any one
of the four charging bays as shown in Figure 5, noting the
orientation of the battery pack. Slide the battery pack into
the charging bay until it stops and then rock the battery
pack back until it snaps into place. The amber indicator di-
rectly under the battery being charged will turn on if the
battery is properly inserted.
of the four charging bays as shown in Figure 5, noting the
orientation of the battery pack. Slide the battery pack into
the charging bay until it stops and then rock the battery
pack back until it snaps into place. The amber indicator di-
rectly under the battery being charged will turn on if the
battery is properly inserted.
The indicators under the battery will allow you to monitor
the charging process per the table below:
Amber
Green
Battery Status
On
Off
Charging
On
Flashing
80% charged (O.K.
to use)
to use)
Off
On
Completely
Charged
Charged
Flashing
Off
Fault
Important • A fault condition is caused by a problem with the battery.
The charger may indicate a fault because the battery is too hot or cold
to charge reliably. Try to charge the battery again when it returns to
the room’s ambient temperature. If the amber indicator starts flashing
on the second attempt, the battery should be discarded. Always
dispose of batteries in a proper manner as described in Appendix E.