Dataram DRI740/16GB プリント
DRI750
DDR3-1066, PC3-8500, Registered, ECC, 1.5V, 240-pin DIMMs
DRI750
23-Nov-10
Products in Family
DRI750/8GB (2 x 4GB 2Rx8 DIMMs)
DRI740/16GB (2 x 8GB 2Rx4 DIMMs)
DRI750/16GB (2 x 8GB 4Rx8 DIMMs)
DRI750/32GB (2 x 16GB 4Rx4 DIMMs)
DRI740/16GB (2 x 8GB 2Rx4 DIMMs)
DRI750/16GB (2 x 8GB 4Rx8 DIMMs)
DRI750/32GB (2 x 16GB 4Rx4 DIMMs)
Features Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.5 V ±0.075
Fully RoHS Compliant
Thermal Sensor
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.5 V ±0.075
Fully RoHS Compliant
Thermal Sensor
Each DRI750 and DRI740 upgrade consists of a single
DDR3-1066 Registered ECC DIMM that conforms to
JEDEC’s DDR3, PC3-8500 standard. One 2K-bit
EEPROM is used for Serial Presence Detect and a
combination register/PLL with Address and Command
Parity is also used. A thermal sensor accurately monitors
the DIMM module and can prevent exceeding the
maximum operating temperature of 95C.
DDR3-1066 Registered ECC DIMM that conforms to
JEDEC’s DDR3, PC3-8500 standard. One 2K-bit
EEPROM is used for Serial Presence Detect and a
combination register/PLL with Address and Command
Parity is also used. A thermal sensor accurately monitors
the DIMM module and can prevent exceeding the
maximum operating temperature of 95C.
Dataram Product
IBM Product
Supported in these IBM systems:
DRI750/8GB
DRI740/16GB
DRI750/16GB
DRI750/32GB
DRI740/16GB
DRI750/16GB
DRI750/32GB
4526
4529
4527
4528
4529
4527
4528
Power 710 and 730 (8231-E2B), Power 720 (8202-E4B),
Power 740 (8205-E6B), Power 750 (8233-E8B), Power
755 (8236-E8C)
Power 740 (8205-E6B), Power 750 (8233-E8B), Power
755 (8236-E8C)
Note: Not all products supported in all systems. See IBM or Dataram
websites for specific memory options for your model.
websites for specific memory options for your model.
Notes
Tolerances on all dimensions
except where otherwise
indicated are
except where otherwise
indicated are
±.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]
Copyright
© 2010 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.