Dataram DRIHX5/4GB プリント
DRIHX5
DDR3-1333, PC3-10600, Registered, ECC, 1.5V, 240-pin VLP DIMMs
DRIHX5
21-Sep-11
Copyright
2011 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRIHX5/4GB
(1 x 4GB 2Rx8 VLP DDR3-1333 DIMM)
DRIHX5/8GB
(1 x 8GB 4Rx8 VLP DDR3-1066 DIMM)
DRIHX52/8GB
(1 x 8GB 2Rx4 VLP DDR3-1333 DIMM)
DRIHX5QL/8GB
(1 x 8GB 4Rx8 VLP DDR3-1333 DIMM)
Features
Description
240-pin JEDEC-compliant Very Low Profile (VLP) DIMMs
133.35 mm wide by 18.7 mm high (.738” x 5.25”)
Data Transfer Rate: up to 10.6 Gigabytes/sec
Operating Voltage: 1.5 V ±0.075
Error Checking and Correction (ECC) bits
Supports Intel SDDC and Chipkill Advanced ECC Features
Fully RoHS Compliant
133.35 mm wide by 18.7 mm high (.738” x 5.25”)
Data Transfer Rate: up to 10.6 Gigabytes/sec
Operating Voltage: 1.5 V ±0.075
Error Checking and Correction (ECC) bits
Supports Intel SDDC and Chipkill Advanced ECC Features
Fully RoHS Compliant
Each DRIHX5 upgrade consists of a matched pair of
DDR3 Registered VLP DIMMs with address/command
parity functionality. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
DDR3 Registered VLP DIMMs with address/command
parity functionality. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Dataram Product
IBM Product
Supported in these IBM systems:
DRIHX5/4GB
DRIHX5/8GB
DRIHX52/8GB
DRIHX5QL/8GB
DRIHX5/8GB
DRIHX52/8GB
DRIHX5QL/8GB
44T1596
46C7499
49Y1555
46C0570
46C7499
49Y1555
46C0570
BladeCenter HX5 (7872, 7832), MAX5 V2 Expansion Unit
(88Y6128), MAX5 V1 Expansion Unit (46M6973)
(88Y6128), MAX5 V1 Expansion Unit (46M6973)
Note: Not all products are supported in all systems/models.
Notes
Tolerances on all dimensions
except where otherwise
indicated are ±.13 (.005).
except where otherwise
indicated are ±.13 (.005).
All dimensions are expressed
in millimeters.
in millimeters.