Dataram 32GB PC3L-8500 Kit DRST4/32GB プリント
製品コード
DRST4/32GB
DRST4
DDR3L-1333, PC3L-10600, Registered, ECC, 1.35V, 240-pin DIMMs
DRST4
04-Nov-11
Copyright
2011 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRST4/8GB (2 x 4GB 2Rx8 DIMMs)
DRST4/16GB (2 x 8GB 2Rx4 DIMMs)
DRST4/32GB (2 x 16GB 4Rx4 DIMMs)
DRST4/16GB (2 x 8GB 2Rx4 DIMMs)
DRST4/32GB (2 x 16GB 4Rx4 DIMMs)
Features
Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35V(1.28V~1.45V) & 1.5V(1.425V~1.575V)
Fully RoHS Compliant
Thermal Sensor
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35V(1.28V~1.45V) & 1.5V(1.425V~1.575V)
Fully RoHS Compliant
Thermal Sensor
Each DRST4 upgrade consists of a matched pair of
DDR3L-1333 Registered ECC DIMMs that conforms to
JEDEC’s DDR3, PC3L-10600 standard. One 2K-bit
EEPROM is used for Serial Presence Detect and a
combination register/PLL with Address and Command
Parity is also used. A thermal sensor accurately monitors
the DIMM module and can prevent exceeding the
maximum operating temperature of 95C.
DDR3L-1333 Registered ECC DIMMs that conforms to
JEDEC’s DDR3, PC3L-10600 standard. One 2K-bit
EEPROM is used for Serial Presence Detect and a
combination register/PLL with Address and Command
Parity is also used. A thermal sensor accurately monitors
the DIMM module and can prevent exceeding the
maximum operating temperature of 95C.
Note: The 16GB DIMM is DDR3L-1066 PC3L-8500
Dataram Product
Sun Microsystems Product
Supported in these Sun Microsystems systems:
DRST4/8GB
DRST4/16GB
DRST4/32GB
DRST4/16GB
DRST4/32GB
7101696
7101697
7101698
7101697
7101698
Oracle / Sun SPARC T4-1, T4-2, T4-4, and T4-1B Server
Module
Module
Notes
Tolerances on all dimensions
except where otherwise
indicated are ±.13 (.005).
except where otherwise
indicated are ±.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]