Dataram 16GB(2 x 8GB) DDR3-1333 DRI740L/16GB プリント
製品コード
DRI740L/16GB
DRI740L
DDR3-1333, PC3-10600, Registered, ECC, 1.35V, 240-pin DIMMs
DRI740L
01-Feb-12
Copyright
2012 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRI740L/8GB (2 x 4GB 2Rx8 DIMMs)
DRI740L/16GB (2 x 8GB 2Rx4 DIMMs)
DRI740L/32GB (2 x 16GB 4Rx4 DIMMs)
DRI740L/16GB (2 x 8GB 2Rx4 DIMMs)
DRI740L/32GB (2 x 16GB 4Rx4 DIMMs)
Features
Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35V(1.28V~1.45V)
Fully RoHS Compliant
Thermal Sensor
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35V(1.28V~1.45V)
Fully RoHS Compliant
Thermal Sensor
Each DRI740L upgrade consists of two DDR3-1333
Registered ECC DIMMs that conform to JEDEC’s DDR3,
PC3L-10600 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Registered ECC DIMMs that conform to JEDEC’s DDR3,
PC3L-10600 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Note: the 32GB kit (16GB DIMMs) is PC3L-8500 / DDR3-1066
Dataram Product
IBM Product
Supported in these IBM systems:
DRI740L/8GB
DRI740L/16GB
DRI740L/32GB
DRI740L/16GB
DRI740L/32GB
EM08
EM16
EM32
EM16
EM32
Power 710 (8231-E1C), 730 (8231-E2C), Power 720
(8202-E4C), Power 740 (8205-E6C)
(8202-E4C), Power 740 (8205-E6C)
Notes
Tolerances on all dimensions
except where otherwise
indicated are ±.13 (.005).
except where otherwise
indicated are ±.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]