Electrolux EWG 12740 W ユーザーズマニュアル

If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged.

It is therefore a good idea to clean it
from time to time.

Turn off the water tap. Unscrew the
water inlet hose. Clean the filter using a
hard bristle brush. Tighten up the inlet
hose. 

If the machine is exposed to tempera-
tures below 0°C, certain precautions
should be taken.

• Turn off the water tap.

• Unscrew the inlet hose.

• Unhook the drain hose from the rear

support and position the end of this
hose and that of the inlet hose in a
bowl. Run the draining programme

«Drain».

• Disconnect the appliance.

• Screw the inlet hose and reposition

the drain hose.

• When you intend to start the

machine up again, make sure that
the room temperature is above 0°C.

P1090

If the water is not discharged, proceed
as follows to empty out the machine:

• pull out the plug from the power

socket; 

• close the water tap; 

• if necessary, wait until the water has

cooled down;

• Unscrew and remove the filter;

• place a bowl on the floor. The water

should drain by gravity into the bowl.
When the bowl is full, empty the
bowl. Repeat the procedure until
water stops flowing out;

• clean the filter if necessary as

previously described;

• screw the filter again.

care and cleaning  electrolux  27

132969690_GB.qxd  13/09/2007  11.38  Pagina  27