Dataram 1 x 4GB 1Rx4 DIMM DRH81333RSL/4GB プリント
製品コード
DRH81333RSL/4GB
DRH81333RL
DDR3-1333, PC3L-10600, Registered, ECC, 1.35V, 240-pin DIMMs
DRH81333RL
17-May-12
Copyright
2012 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRH81333RSL/4GB (1 x 4GB 1Rx4 DIMM)
DRH81333RL/8GB (1 x 8GB 2Rx4 DIMM)
DRH81333RL/16GB (1 x16GB 2Rx4 DIMM)
DRH81333RL/8GB (1 x 8GB 2Rx4 DIMM)
DRH81333RL/16GB (1 x16GB 2Rx4 DIMM)
Features
Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181
133.35 mm wide by 30 mm high (1.181
” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35 V ±0.075 (1.5 V tolerant)
Fully RoHS Compliant
Thermal Sensor
Heat Spreader
HP SmartMemory compliant
Operating Voltage: 1.35 V ±0.075 (1.5 V tolerant)
Fully RoHS Compliant
Thermal Sensor
Heat Spreader
HP SmartMemory compliant
Each DRH81333RL upgrade consists of a single DDR3-
1333 Registered DIMM
1333 Registered DIMM
that conforms to JEDEC’s DDR3,
PC3L-10600 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Dataram Product
HP Product
Supported in these HP systems:
DRH81333RSL/4GB
DRH81333RL/8GB
DRH81333RL/16GB
DRH81333RL/8GB
DRH81333RL/16GB
647893-B21
647897-B21
647901-B21
647897-B21
647901-B21
ProLiant BL460c G8, DL160 G8, DL360p G8, DL380p
G8, ML350p G8, SL230s G8, SL250s G8
G8, ML350p G8, SL230s G8, SL250s G8
Notes
Tolerances on all dimensions
except where otherwise
indicated are
except where otherwise
indicated are
.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]