JVC LT-23D50BK ユーザーズマニュアル

- 26 -

Manual Search:
This is for searching for digital channels on

a single broadcast frequency. The frequency

channel number (21-68) is entered in the

box at the top left of the screen and the re-

ceived signal level and signal quality can be

observed on the two bar graphs at the bot-

tom. When OK is pressed, the TV searches

that frequency and display a list of the chan-

nels found.

Hint
The bar graphs of signal quality and signal

level give a good indication of whether any

channels are likely to be found. If only the

signal level graph shows a high value then

it is likely that an analogue channel occu-

pies that broadcast frequency. If the signal

quality bar is high as well then it is a digital

frequency and digital channels will prob-

ably be found.
Again, channels which duplicate those al-

ready in the channel list are ignored. How-

ever, the manual channel search will find all

channels on the broadcast frequency.
When either search is finished, press the

MENU key to return to normal broadcast

viewing, to watch the new digital terrestrial

television channels found.

First Time Installation:

To reset the TV, highlight the First Time In-

stallation line in the menu and press OK. A

warning screen is displayed in case of acci-

dental operation.

$UH\RXVXUH\RXZDQWWRGHOHWHDOOFKDQQHOV

DQGVHWWLQJVIRUILUVWWLPHLQVWDOODWLRQ"

<HV

Highlight the YES button with the or

key and press OK to erase all the channels

and settings and switch the receiver to

standby.

Common Interface

It is required to subscribe to a pay channel

company to view the pay channels of the

Digital Terrestrial broadcasting.
Obtain the Conditional Access Module

(CAM) and the Viewing card by subscribing

to a pay channel company, then insert those

to the Television using the following proce-

dure.
1. Switch off the TV and unplug from the

mains.
2. Insert the CAM, then Viewing Card to the

slot that is located in the terminal cover at

the left-hand side of the TV (from front

view).
The CAM should be correctly inserted, it is

impossible to insert fully if reversed. The

CAM or the TV terminal may be damaged if

the CAM is forcefully inserted.
3. Connect the TV to the mains supply,

switch on and then wait for few moments

until the card is activated.
Some CAMs may require the following set

up. Please set the CAM by entering the DTV

menu, Common Interface then pressing OK

button. (CAM set up menu is not displayed

when it is not required.)
To see the viewing contract information,

press MENU, Select DTV and Press OK,

then Select Common Interface and press

OK.

When no module is inserted, No CI Mod-

ule appears.

Refer to the module instruction manual for

details of the settings.

ENG-IDTV-JVC-1724W-17 INCH TFT LCD.230205.p65

24.02.2005, 08:19