Toshiba 4540c with GA-1211-EX ユーザーズマニュアル

Operations From the Control Panel    37

y

The above screen is not displayed under the following conditions:
-

You scan the original from the Reversing Automatic Document Feeder

*

 without pressing [CONTINUE] to 

scan additional originals.

-

A scan preview is displayed.

y

To cancel the operation, press [JOB CANCEL].

y

To change the scan settings, press [SCAN SETTING]. For details, refer to the Scanning Guide.

*

The Reversing Automatic Document Feeder is optional for the e-STUDIO4540C Series.

y

When the equipment has scanned more than 1000 pages in a job, the “The number of originals exceeds the 
limit. Do you want to save stored originals?” message appears. If you want to save the scans, press [YES].

y

When the temporary workspace is full on the equipment’s hard disk, the “Not enough Work Space to store 
originals. Will you save stored originals?” message appears. If you want to save the scans, press [YES]. 
The available workspace can be viewed on the TopAccess [Device] tab.

y

If the number of jobs waiting to store scans in the equipment's hard disk exceeds 20, a message appears to 
indicate that the equipment’s memory is full. In this case, wait a while until memory becomes available again 
or delete unnecessary jobs from [JOB STATUS].
For instructions on how to view the scan job status, refer to the Scanning Guide.

When you perform scanning by using [SMB/FTP/OTHER], the message “OK” may be displayed in the “Status” 
column of the SCAN LOG screen, even if the job process has failed due to a problem, such as specifying a 
wrong storage location.

To find information about problems causing job process failure, see the following section:

 P.56 “Scanning Problems”

For instructions on how to display the SCAN LOG screen, refer to the Scanning Guide.