Transcend Information TS-USP3 ユーザーズマニュアル

HARDWARE INSTALLATION

2.4 Connector Description

2.4.1 Primary/Secondary IDE Connectors

This motherboard supports two 40-pin IDE connectors marked as IDE1 (primary channel) and

IDE2 (secondary channel). Each channel supports two IDE devices for a total of four devices.

Connect your Hard Disk (the main one if you are using more than one) to the “Master” connector

(at the end of the cable) and connect it to IDE1 (see important note below). If your HDD supports

Ultra DMA/66, you must use an 80-wire cable, otherwise the HDD won’t be able to reach this

speed.

If you intend to operate two IDE devices from the same channel, one device must be set to

“Master” mode and the other to “Slave” mode. A Hard Disk Drive, CD ROM Drive or other IDE

device can have either setting, depending on device’s jumper setting. Please refer to the device’s

manual for more information.

NOTE: The Connectors must be attached to the IDE channels correctly. Make sure

that the red stripe on the edge of the ribbon cable (this may be faint and

could be a dotted line) is the nearest to PIN 1 (on the left as the motherboard

is shown in the picture below).

IDE Connectors

P I N 1

S e c o n d a r y I D E C o n n e c t o r

Primary IDE Connector

I D E 2

I D E 1

IDE

DIMM1 (64bit 168pin SDRAM Module)

DIMM2 (64bit 168pin SDRAM Module)

PCI Slot1 (PCI1)

PCI Slot2 (PCI2)

PCI Slot3 (PCI3)

CPU-FAN

WOL

FDC

IDE2

IDE1

GMCH

COMB

AC97

IntelICH

66/100MHz

Pin1

COMA

VGA

Parallel Port

Game Port

Line_in

MIC

Line_out

Li Battery

Transcend