Tunturi E4R ユーザーズマニュアル

 Secure the rear foot with two M10 bolts (D) 

and washers (E) to the lower frame. At this point 
tighten the bolts only with your fingers. 

 Lift the cycle on the floor and turn it right side 

up. 

 Fasten the front foot with the transportation 

wheels to the front frame the same way.

 Remove the M5 screws in the front and seat 

frames.

 Connect the handgrip pulse wires with the 

connectors in the front frame.

 Join the front frame and seat frame by pushing 

one tube inside the other so that the screw holes 
in the tubes match together. 

 Fasten the frames with two M8 screws (F) and 

washers (C). Do not damage the hand grip pulse 
wires.

 Secure the drink bottle rack in place with the 

M5 screws.

 Tighten the rear and front foot screws.

 Push the plastic caps over the nuts.

 Push the fastening screw (G) through the hole 

in the seat frame tube and the assembly plate. 

 Place the bushing (H) on the fastening screw 

and secure the plate by tightening the nut (I) on 
the fastening screw. 

 Remove the fastening nuts and washers of 

the seat back and attach the seat back to the 
assembly plate with them. 

 Push the plastic caps over the nuts.