Tunturi E45 ユーザーズマニュアル

The pedals are distinguished by the markings R (= right) 

and L (= left) on their shafts. Fasten the right pedal to 

the right pedal crank turning clockwise and the left 

pedal to the left pedal crank turning counterclockwise. 

Fasten the pedal bands first into the retainerat the 

device. Thread the band through the pedal loop and 

push the band opening into the projection in the pedal. 

Fasten the pedal bands to the pedal outside. Push the 

band through the locking buckle and the band locks 

automatically. The length of the band can be adjusted 

with the locking buckle.

Attach the cable coming from the frame tube to the 

connector at the bottom of the handlebar. 

Ensure that the joint is securely locked by gently pulling 

the wire. Thread the wire carefully inside the frame tube 

and push the handlebar support tube into place inside 

the frame tube so that the fastening screws are on the 

front of the tube.

 Use the enclosed Allen key to tighten both 

fastening screws through the holes in the tube.

Tighten the fastening screws by turning them counter-

clockwise.

Connect the cables from the handlebar to the 

corresponding connectors of the console. Insert the 

connected cables into the console, but make sure they 

are not damaged when the console is attached. Place the 

meter in position at the end of the handlebar support 

tube and attach the console using 4 mounting screws.