Tunturi E60 ユーザーズマニュアル

The pedals are distinguished by the markings R (= right) 

and L (= left) on their shafts. Fasten the right pedal to 

the right pedal crank turning clockwise and the left 

pedal to the left pedal crank turning counterclockwise. 

Fasten the pedal bands first into the retainerat the 

device. Thread the band through the pedal loop and 

push the band opening into the projection in the pedal. 

Fasten the pedal bands to the pedal outside. Push the 

band through the locking buckle and the band locks 

automatically. The length of the band can be adjusted 

with the locking buckle.

Attach the cable coming from the frame tube to the 

connector at the bottom of the handlebar. Ensure that 

the joint is securely locked by gently pulling the wire. 

Thread the wire carefully inside the frame tube. Open 

the handlebar locking knob by turning it anticlockwise 

a few times and then pulling it outwards. Insert the 

handlebar into the front frame tube. Release the locking 

knob once the handlebar has reached the required level. 

Ensure that the handlebar is locked. Secure and tighten 

the locking knob by turning it clockwise. 

Connect the cables from the handlebar to the 
corresponding connectors of the console. Insert the 
connected cables into the console, but make sure they 
are not damaged when the console is attached. Place the 
meter in position at the end of the handlebar support 
tube and attach the console using 4 mounting screws.

Loosen the seatholder locking screw and turn the upper 
locking lever so that it is aligned with the equipment. 
Place the seat into position on the grooves of the lower 
locking lever. Turn the upper locking lever towards the 
top of the seat rails and lock the seat by tightening the 
locking screw.