Frigidaire FPGC3087MS ユーザーズマニュアル

11

The burner grates are dishwasher safe and may be 

cleaned in the dishwasher. Remove any excessive soils 

before placing in the dishwasher.

Should you ever need to remove the burner caps for 

cleaning lift the burner cap off the burner head. Clean 

heavy soils with an absorbent cloth. Rinse with a clean, 

damp cloth and immediately thoroughly dry including the 

bottom and inside of the cap. Do not use harsh abrasive 

cleaners. They can scratch the porcelain on the cap. Do 

not clean burner caps in dishwasher. 
When placing the burner caps, see Important note below.

Your appliance is shipped with the burner heads and 

burner caps in the correct locations. Before using your 

gas appliance be sure to:
● Follow installation instructions before operating.
● Remove all packing tape from cooktop area.

●  To avoid possible burns use care when cleaning the 

cooktop. DO NOT attempt to clean the cooktop 

whenever the cooktop or burner heads are still hot.

●  To avoid possible burns DO NOT attempt any of 

the following cleaning instructions provided before 

turning OFF all of the surface burners and allow 

them to cool.

●  To avoid possible burns DO NOT attempt to operate 

the surface burners without the burner caps.

●  For proper gas fl ow and ignition of the burners 
  — DO NOT allow spills, food, cleaning agents 

●  The cooktop is not removable. Do not attempt to 

remove or lift the cooktop.

When placing the burner caps on the cooktop, be sure 

the burner caps are seated fi rmly on top of burner 

heads. Improper fl ame size and uneven heating may 

result when any surface burners are turned ON and the 

burner caps are not seated correctly.

Lift the burner cap from the burner head. The surface 

burner heads are secured to the cooktop and must be 

cleaned in place.
For proper gas fl ow it may be necessary to clean the 

burner heads and slots. To clean, fi rst use a clean DAMP 

cloth to soak up any spills. Remove any food from 

between the burner slots using a small nonabrasive brush 

like a toothbrush and afterwards wipe using a damp 

cloth. For stubborn soils located in the slots, use a small-

gauge wire or needle to clean.
Should you experience ignition problems it may be that 

an ignition port hole is partially blocked with soil. With 

the burner head in place, use a small wire gauge needle 

or the end of a paper clip to clear the ignition port or 

ports.

Slots

Ignition port

Orifi ce port

Slots

Ignition port

Orifi ce port

Orifi ce port

Figure 2- Dual ring burner head

Figure 1- Regular burner head